Все видео

More Shop Solutions: http://woodgears.ca/reader/walters/shop_solutions.html How To video for installing and recovering threaded metal inserts for wood.

I moved the feeder 10 feet for a better camera angle and the birds were not happy about it... chirping and complaining they sound like a bunch of crickets. Ruby-throated humming birds found in southwestern Missouri, Missouri Ozarks Sept 2012.

Construction Article: http://woodgears.ca/reader/walters/thrust_bearing.html Sometimes you get ahead of yourself in a project or change your mind about how something should work. I had already cut the center out of the large wood section, and then later decided to add the bearing race. Before I could route the...

Construction Article: http://woodgears.ca/reader/walters/thrust_bearing.html I wanted to make a flat thrust bearing (similar to a lazy susan) using marbles. I experimented with 9/16" diameter glass marbles, 5/8" ball bearings and a method to make them run evenly in the tack. Check this out by pocket83 who spent a...

How To Video shows how I repaired an unfortunate hole drilled in the top of my table saw by a router bit. Grizzly G1023 Table Saw

Shop Solutions Page 2: http://woodgears.ca/reader/walters/shop_solutions2.html How To Video of a mobile stand for a portable planer using kick-up out of the way wheels for on the ground stability. I could have mounted the wheels with a wider stance but then I'd be tripping over them. This was fairly easy to build...

More Dust Collection: http://woodgears.ca/reader/walters/dust_extraction.html How To Video showing a not-so-simple modification to a scroll saw for effective dust collection. This Delta 40-530 Scroll Saw proved more difficult to modify for dust collection. This is a more complicated way of solving the problem but...

Construction Article: http://woodgears.ca/reader/walters/cr_wheels.html Making solid wood clock wheels using circumferential and radial wood grain orientation to minimize the chance of having the wheel split or distort due to climatic changes. In a discussion regarding how to make a wood gear using segmented wood...

Construction Article: http://woodgears.ca/reader/walters/cr_wheels.html The question with C&R wood grain orientation became how to produce a wood ring with as perfect as possible inside diameter. An accurate outside diameter is easy to produce but once the center of the blank is cut out, the center point reference...

Construction Article: http://woodgears.ca/reader/walters/cr_wheels.html A way to accurately position paper patterns on a wood blank with the center already drilled. An experiment in making very large segmented wood clock wheel for the Solaris Clock by Clayton Boyer

Construction Article: http://woodgears.ca/reader/walters/cr_wheels.html Ways to improve the Inside Diameter Sanding Jig An experiment in making very large segmented wood clock wheel for the Solaris Clock by Clayton Boyer

Shop Solutions Page 2: http://woodgears.ca/reader/walters/shop_solutions2.html Once a sanding disc has been on a disc sander for a while, it is a mess to strip the old one off and clean up the metal disk prior to installing fresh sandpaper. This is the easiest method I have come up with.

Construction Article: http://woodgears.ca/reader/walters/ujoint.html Double joint driveline explained and demonstrated. Construction article at woodgears.ca

Construction Article: http://woodgears.ca/reader/walters/ujoint.html I made a few improvements. I decided on 5/16" dowel for the cross pins. I wanted the joint to move freely and decided I could accept a loose fit to allow for expected dimensional changes in the wood. 21/32" was selected as mating hole for the...

Construction Article: http://woodgears.ca/reader/walters/ujoint.html I thought a wood universal joint would be fun to use on some projects, but first I had to figure out how to make one. Construction article at woodgears.ca